5054_w16_qp_21
A paper of Physics, 5054
Questions:
10
Year:
2016
Paper:
2
Variant:
1
Login to start this paper & get access to powerful tools
1
A car of mass 800 kg is travelling at a speed of 25 m / s along a straight, horizontal road. State how velocity differs from speed. The driver presses the accelerator and the speed of the car starts to increase from 25 m / s. The car accelerates at 1.5 m / s2. Calculate the resultant force acting on the car as it accelerates. force = Explain why the forward force acting on the car due to the engine is greater than the value in . Determine the speed of the car 4.0 s after it starts to accelerate. speed =
1. Motion, forces and energy  →  1.2. Motion
1. Motion, forces and energy  →  1.5.4. Circular motion
1. Motion, forces and energy  →  1.7.2. Work
Open
2
shows a bed that folds away against a wall during the day. wall hinge bed 0.35 m 0.30 m leg W (not to scale) When it is horizontal, the bed is supported on one side by a hinge and on the other side by two legs. The weight W of the bed acts through its centre of mass, which is at a horizontal distance of 0.35 m from the hinge. The mass of the bed is 26 kg. The gravitational field strength g is 10 N / kg. Calculate the weight W of the bed. W = State the principle of moments. Determine the size of the total upward force exerted on the bed by the two legs when the bed is horizontal. total force =
1. Motion, forces and energy  →  1.5.5. Turning effect of forces
1. Motion, forces and energy  →  1.5.6. Centre of gravity
Open
3
A large power station burns oil to heat water in a boiler. State the name of the form of energy stored in the oil before it is burnt. State and explain whether oil is a renewable or a non-renewable energy source. Describe one environmental issue caused by burning oil to generate electricity in a power station. State what is meant by efficiency. The efficiency of the power station is 0.38 (38%). Its electrical power output is 1.9 × 109 W. Calculate 1. the input power to the power station, input power = 2. the energy wasted in 2.0 hours. energy wasted =
1. Motion, forces and energy  →  1.7.3. Energy resources
1. Motion, forces and energy  →  1.7.4. Efficiency
Open
4
A lamp is positioned at the bottom of a small pool of water. The critical angle for light passing from water into air is 49°. Explain what is meant by the term critical angle. The lamp sends light towards the surface of the pool. shows three rays of light that are at 30°, 60° and 90° to the horizontal. lamp horizontal 90° 60° 30° air water On , draw the path taken by each of the three rays after they strike the surface of the water.
3. Waves  →  3.2.2. Refraction of light
3. Waves  →  3.2.1. Reflection of light
Open
5
shows a loudspeaker inside a glass bell-jar that contains air. air tube loudspeaker glass bell-jar The loudspeaker produces a sound of frequency 2200 Hz. State what is meant by the frequency of a sound. The speed of sound in air is 330 m / s. Calculate the wavelength of the sound in the air. wavelength = The sound passes from the air into the glass. State what happens to 1. the frequency of the sound, 2. the speed of the sound. Describe 1. how sound is produced by the loudspeaker, 2. how sound is transmitted through the air. A pump is connected to the tube at the bottom of the glass bell-jar. The pump is switched on and it removes the air from the glass bell-jar. Explain why the volume of the sound heard outside the glass bell-jar decreases.
3. Waves  →  3.4. Sound
Open
6
Two flexible iron strips, WX and YZ, are placed close to each other inside a solenoid (long coil). The end W of WX and the end Z of YZ are held firmly in position. shows that the solenoid is connected to a d.c. power supply and a switch. switch W Z X Y solenoid flexible iron strips d.c. power supply The switch is closed and there is an electric current in the solenoid. End W of flexible iron strip WX becomes a magnetic S-pole. State the type of magnetic pole produced at X, Y and Z. 1. X -pole 2. Y -pole 3. Z -pole State and explain what happens to X and Y because the flexible iron strips are magnetised. A relay operates a switch in one circuit using the current in a different circuit. State one example of a relay used in this way and explain why a relay is used.
4. Electricity and magnetism  →  4.1. Simple magnetism and magnetic fields
Open
7
The a.c. mains electricity system in a house consists of three wires: the live, the neutral and the earth. State the purpose of the live wire. Explain why the neutral wire is needed. Each circuit in the house includes a fuse for protection. An electrical appliance is switched on and the current in the fuse becomes greater than the rating of the fuse. State and explain what happens. State and explain in which of the three wires the fuse is located.
4. Electricity and magnetism  →  4.4.2. Electrical safety
Open
8
Sodium-24 and sodium-23 are two of the isotopes of sodium. Sodium-24 is a radioactive isotope that emits beta-particles and gamma-rays as it decays. The nuclide notation for the isotope sodium-24 is 2 1Na. Describe the composition and structure of a neutral atom of sodium-24. State how the composition of a nucleus of sodium-24 differs from the composition of a nucleus of sodium-23. A nucleus of sodium-24 decays. It emits a beta-particle and produces a nucleus of an isotope of magnesium (Mg). State the name of the particle that is identical to a beta-particle. Complete the nuclide equation for the emission of a beta-particle (β) by sodium-24. 1Na β + Mg When it decays, sodium-24 also emits gamma-rays. State what gamma-rays are. shows a beam of beta-particles and a beam of gamma-rays entering the electric field between two oppositely charged plates. beam of beta-particles beam of gamma-rays + + + + + + + + – – – – – – – – (not to scale) On , draw the path of the beta-particles in the electric field between the charged plates. On , draw the path of the gamma-rays in the electric field between the charged plates. Explain why the path taken by the beta-particles differs from that taken by the gamma- rays. Sodium-24 is sometimes used in diagnosing medical conditions. The half-life of sodium-24 is 15 hours. Explain one reason why a half-life of 15 hours makes the isotope suitable for use in the human body.
5. Nuclear physics  →  5.2.5. Half-life
5. Nuclear physics  →  5.1.2. The nucleus
Open
9
The primary coil of a transformer is connected to the 230 V a.c. mains supply. Describe how the transformer operates. The output voltage of the transformer is alternating and cannot be used directly as a d.c. power supply. In the space below, draw the symbol of a circuit component that allows the current to pass in only one direction and state the name of the component. circuit symbol name of component: shows a d.c. power supply being used to charge a rechargeable battery. + + – – 5.0 V d.c. power supply 5.2 Ω current direction rechargeable battery The rechargeable battery is in series with the d.c. power supply and a 5.2 Ω resistor. The e.m.f. of the power supply is 5.0 V. Explain what is meant by e.m.f. The e.m.f. of the power supply and the e.m.f. of the battery act against each other in opposite directions in the circuit. The e.m.f. of the battery is 3.7 V. 1. Calculate the resultant e.m.f. in the circuit. resultant e.m.f. = 2. Calculate the current in the circuit. current = 3. The current in the circuit remains constant as the battery is charged. Calculate the charge that passes through the resistor in 1.5 hours. charge = A battery charger has a plastic casing and double insulation. The battery charger is not earthed. Explain why it is not necessary for the battery charger to be earthed.
4. Electricity and magnetism  →  4.5.6. The transformer
Open
10
A particular type of cooking oil is a liquid at room temperature. At room temperature, air is easily compressed but the oil cannot be compressed. Explain, in terms of molecules, why the density of the oil is much greater than that of a gas, why the oil cannot be compressed. Some of the oil is poured into a metal pan. The oil in the pan has a mass of 680 g. The density of the oil is 0.85 g / cm3. Calculate the volume of oil in the pan. volume = The pan is placed on an electric hotplate, as shown in . handle oil pan hotplate The specific heat capacity of the oil is 2.0 J / (g °C). The oil is heated from 20 °C to its boiling point of 260 °C. State what is meant by boiling point. Calculate the thermal energy needed to heat the 680 g of oil to its boiling point. thermal energy = Suggest one reason why the energy output from the hotplate, when heating the oil, is larger than the value calculated in .
2. Thermal physics  →  2.2.2. Specific heat capacity
2. Thermal physics  →  2.2.3. Melting, boiling and evaporation
2. Thermal physics  →  2.2.1. Thermal expansion of solids, liquids and gases
Open