0625_s10_qp_33
A paper of Physics, 0625
Questions:
11
Year:
2010
Paper:
3
Variant:
3
Login to start this paper & get access to powerful tools
1
For Examiner’s Use A ball player bounces a ball of mass 0.60 kg. Its centre of mass moves down through a distance of 0.90 m, as shown in . Ignore air resistance throughout this question. 0.90 m Calculate the decrease in gravitational potential energy of the ball as it moves down through the 0.90 m. decrease in PE = The ball hits the ground at 7.0 m/s. Calculate the initial energy given to the ball by the player. energy given = For Examiner’s Use On another occasion, the player throws the ball into the air, to a height of 4.0 m above the ground. The ball then falls to the ground. During the impact, 22% of the ball’s energy is lost. Suggest one reason why energy is lost during bouncing. Calculate the height to which the ball rises after the bounce. An observer who sees the ball bounce says, “That ball should be slightly warmer after that bounce.” Explain why the observer’s statement is true.
1. Motion, forces and energy  →  1.7.1. Energy
6. Space physics  →  6.1.2. The Solar System
Open
2
For Examiner’s Use Four students, A, B, C and D, each have a spring. They measure the lengths of their springs when the springs are stretched by different loads. Their results are shown in . student A student B student C student D load / N spring length / cm spring length / cm spring length / cm spring length / cm 0.5 6.7 9.2 9.1 10.0 1.0 7.7 10.0 9.9 11.1 1.5 8.7 10.8 10.7 12.2 2.0 9.7 11.6 11.5 13.3 2.5 10.7 12.6 12.3 14.4 3.0 11.7 13.8 13.1 15.5 3.5 12.7 15.2 13.9 16.6 4.0 13.7 16.8 14.7 17.7 State which student had loaded the spring beyond the limit of proportionality. Explain how you obtained your answer to . For the spring used by student A, calculate the extra extension caused by each additional 0.5 N, extra extension = the unloaded length of the spring. unloaded length = For Examiner’s Use Student A obtains a second spring that is identical to his first spring. He hangs the two springs side by side, as shown in . identical springs load Use the table to calculate the length of each of the springs when a load of 2.5 N is hung as shown in . Show your working. length =
1. Motion, forces and energy  →  1.5.1. Effects of forces
Open
3
For Examiner’s Use An ornamental garden includes a small pond, which contains a pumped system that causes water to go up a pipe and then to run down a heap of rocks. shows a section through this water feature. 0.8 m rocks pumped water rises through pipe water inlet to pump water runs down rocks pump The density of water is 1000 kg / m3. A volume of 1 litre is equal to 0.001 m3. Calculate the mass of 1 litre of water. mass = Calculate the work done raising 1 litre of water through a height of 0.8 m. work = For Examiner’s Use The pump lifts 90 litres of water per minute. Calculate the minimum power of the pump. power = The pump is switched off. Immediately after the pump is switched off, what is the value of the water pressure at the bottom of the 0.8 m pipe, due to the water in the pipe? pressure =
1. Motion, forces and energy  →  1.8. Pressure
1. Motion, forces and energy  →  1.7.4. Power
Open
4
For Examiner’s Use A technician has been asked to design a liquid-in-glass thermometer, using alcohol as the liquid. State what is meant by the sensitivity of the thermometer. State one design feature the technician could use in order to ensure a very sensitive thermometer. State what is meant by the range of the thermometer. State one design feature that would ensure that the thermometer measured the desired range of temperatures. State what is meant by linearity, as it applies to the thermometer. State one design feature that would ensure linearity in the technician’s thermometer.
2. Thermal physics  →  2.2.2. Specific heat capacity
4. Electricity and magnetism  →  4.2.4. Resistance
2. Thermal physics  →  2.2.1. Thermal expansion of solids, liquids and gases
Open
5
For Examiner’s Use The apparatus shown in is used to demonstrate how a coin and a piece of paper fall when they are released from rest. piece of paper tube containing air coin A At the positions shown in , the paper is descending at constant speed but the coin still accelerates. In terms of the forces acting, explain these observations. paper coin A vacuum pump is now connected at A and the air in the tube is pumped out. The paper and coin are again made to fall from rest. State one difference that would be observed, compared with what was observed when air was present.
1. Motion, forces and energy  →  1.5.1. Effects of forces
1. Motion, forces and energy  →  1.2. Motion
Open
6
For Examiner’s Use A ray of monochromatic light passes through the glass prism shown in . ray 90° 45° 45° 61° glass air A B C State what is meant by the term monochromatic. State the name given to what happens to the ray at A. Use the values on the diagram to calculate the angle of refraction at A (The angles in a triangle add up to 180°). angle of refraction = Calculate the refractive index of the glass. refractive index = For Examiner’s Use Explain why the ray does not emerge into the air at B, but does emerge at C. An identical prism is stuck to the first prism using a transparent adhesive with the same refractive index as the glass. This is shown in . glass glass air ray A B On , draw the path of the ray after it has reached B and until it has passed into the air again.
3. Waves  →  3.2.2. Refraction of light
3. Waves  →  3.2.4. Dispersion of light
Open
7
For Examiner’s Use A disused railway line has a length of 300 m. A man puts his ear against one end of the rail and another man hits the other end with a metal hammer, as shown in . 300 m railway line hammer hits rail man with ear against rail State an approximate value for the speed of sound in air. Sound travels at 5000 m / s in steel. Calculate the time it takes for the sound to travel along the rail. time taken = The man with his ear to the railway line actually hears two sounds from the hammer, separated by a short interval. Explain why he hears two sounds.
3. Waves  →  3.4. Sound
1. Motion, forces and energy  →  1.2. Motion
Open
8
For Examiner’s Use State the law of attraction and repulsion between electrostatic charges. Sometimes, when people have been riding in a car, they get an electric shock from the door handle as they get out of the car. Suggest why this happens. A plastic rod is rubbed with a cloth and becomes positively charged. After charging, the rod is held close to the suspended table-tennis ball shown in . The table-tennis ball is covered with metal paint and is initially uncharged. positively charged rod light table-tennis ball covered with metal paint nylon thread Describe what happens to the charges on the metal-painted table-tennis ball as the positively-charged rod is brought close to the ball. For Examiner’s Use The ball is attracted towards the charged rod. Explain why this happens. When it is a few centimetres away from the rod, the ball is briefly touched by a wire connected to earth. In terms of the movement of charges, describe what happens to the charge on the ball.
4. Electricity and magnetism  →  4.2.1. Electric charge
Open
9
For Examiner’s Use The circuit in contains a 4.0 V battery, whose resistance can be ignored. There are also three resistors, a 3-position switch, S, and another component, P. S A C P B 22  2  8  4.0 V State the name of component P. Deduce the resistance of the circuit when switch S is connected to point A, resistance = point B. resistance = For Examiner’s Use State the current in component P when S is in position C, and explain your answer. current = explanation The 22  resistor is removed as shown in . S A C P B 2  8  4.0 V Showing your working, decide which switch position will result in energy release from the circuit at the rate of 2.0 W. switch position =
4. Electricity and magnetism  →  4.3.3. Action and use of circuit components
4. Electricity and magnetism  →  4.2.4. Resistance
Open
10
For Examiner’s Use 10 A student is using a cathode-ray oscilloscope to display the waveform of an alternating current supply. The arrangement is shown in . a.c. supply R Y-input switch S cathode-ray oscilloscope When switch S is closed, the trace seen on the screen is as shown in . To get this trace, the settings of the oscilloscope controls are volts / cm: 5 V / cm time-base: 10 ms / cm 1 cm On , carefully draw what is seen on the screen when the frequency of the supply is increased to 1.5 times its previous value. For Examiner’s Use What change, if any, must be made to the oscilloscope volts / cm and time-base controls in order to reduce the peak-to-peak height of the trace to half that shown in ? volts / cm setting time-base setting
4. Electricity and magnetism  →  4.5.2. The a.c. generator
4. Electricity and magnetism  →  4.2.2. Electric current
Open
11
For Examiner’s Use 11 A radium source emits ,  and  radiations. illustrates what happens to these radiations when they pass through a magnetic field. The left hand beam is actually deviated a great deal less than shown on . radioactive source On , label the three radiations by writing in the boxes provided. State the direction of the magnetic field that gives the deflections shown in .
4. Electricity and magnetism  →  4.1. Simple phenomena of magnetism
4. Electricity and magnetism  →  4.5.4. Force on a current-carrying conductor
Open