0625_s19_qp_41
A paper of Physics, 0625
Questions:
9
Year:
2019
Paper:
4
Variant:
1
Login to start this paper & get access to powerful tools
1
A rocket is stationary on the launchpad. At time t = 0, the rocket engines are switched on and exhaust gases are ejected from the nozzles of the engines. The rocket accelerates upwards. shows how the acceleration of the rocket varies between time t = 0 and time t = tf. acceleration tf time t Define acceleration. On , sketch a graph to show how the speed of the rocket varies between time t = 0 and time t = tf. tf time t speed Some time later, the rocket is far from the Earth. The effect of the Earth’s gravity on the motion of the rocket is insignificant. As the rocket accelerates, its momentum increases. State the principle of the conservation of momentum. Explain how the principle of the conservation of momentum applies to the accelerating rocket and the exhaust gases.
1. Motion, forces and energy  →  1.6. Momentum
Open
2
shows a sign that extends over a road. 1.8 m W 1.3 m concrete block P 70 cm support post sign ACCIDENT SLOW DOWN The mass of the sign is 3.4 × 103 kg. Calculate the weight W of the sign. W = The weight of the sign acts at a horizontal distance of 1.8 m from the centre of the support post and it produces a turning effect about point P. Point P is a horizontal distance of 1.3 m from the centre of the support post. Calculate the moment about P due to the weight of the sign. moment = A concrete block is positioned on the other side of the support post with its centre of mass a horizontal distance of 70 cm from the centre of the support post. 1. State what is meant by centre of mass. 2. The weight of the concrete block produces a moment about point P that exactly cancels the moment caused by the weight W. Calculate the weight of the concrete block. weight = The concrete block is removed. The sign and support post rotate about point P in a clockwise direction. State and explain what happens to the moment about point P due to the weight of the sign as it rotates.
1. Motion, forces and energy  →  1.5.2. Turning effect of forces
1. Motion, forces and energy  →  1.5.3. Centre of gravity
Open
3
A cube of side 0.040 m is floating in a container of liquid. shows that the surface of the liquid is 0.028 m above the level of the bottom face of the cube. cube liquid pump 0.040 m air 0.028 m valve The pressure of the air above the cube exerts a force on the top face of the cube. The valve is closed. Explain, in terms of air molecules, how the force due to the pressure of the air is produced. The density of the liquid in the container is 1500 kg / m3. Calculate: the pressure due to the liquid at a depth of 0.028 m pressure = the force on the bottom face of the cube caused by the pressure due to the liquid. force = The valve is opened and liquid is pumped into the container. The surface of the liquid rises a distance of 0.034 m. The cube remains floating in the liquid with its bottom face 0.028 m below the surface of the liquid. Calculate the work done on the cube by the force in . work done = Suggest one reason why this is not an efficient method of lifting up the cube.
1. Motion, forces and energy  →  1.8. Pressure
Open
4
Gas of mass 0.23 g is trapped in a cylinder by a piston. The gas is at atmospheric pressure which is 1.0 × 105 Pa. shows the piston held in position by a catch. gas catch heater piston cylinder air at atmospheric pressure The volume of the trapped gas is 1.9 × 10–4 m3. An electrical heater is used to increase the temperature of the trapped gas by 550 °C. The specific heat capacity of the gas is 0.72 J / (g °C). Calculate the energy required to increase the temperature of the trapped gas by 550 °C. energy = The power of the heater is 2.4 W. 1. Calculate how long it takes for the heater to supply the energy calculated in . time = 2. In practice, it takes much longer to increase the temperature of the gas by 550 °C using the heater. Suggest one reason for this. When the temperature of the gas has increased by 550 °C, its pressure is 2.9 × 105 Pa. The catch is then released allowing the piston to move. As the piston moves, the temperature of the gas remains constant. State and explain what happens to the piston. Determine the volume of the gas when the piston stops moving. volume =
2. Thermal physics  →  2.1.3. Gases and the absolute scale of temperature
2. Thermal physics  →  2.2.1. Thermal expansion of solids, liquids and gases
Open
5
Liquids and gases are two states of matter. In both boiling and evaporation, a liquid changes into a gas. State two ways in which boiling differs from evaporation. 1. 2. Before injecting a patient, a doctor wipes a small amount of a volatile liquid on to the patient’s skin. Explain, in terms of molecules, how this procedure cools the patient’s skin. Gases can be compressed but liquids are incompressible. Explain, in terms of molecules, why liquids are incompressible.
2. Thermal physics  →  2.2.3. Melting, boiling and evaporation
Open
6
Green light of frequency 5.7 × 1014 Hz is travelling in air at a speed of 3.0 × 108 m / s. The light is incident on the surface of a transparent solid. shows the wavefronts and the direction of travel of the light in the air. air wavefront solid The light travels more slowly in the transparent solid. Explain, in terms of the wavefronts, why the light changes direction as it enters the solid. You may draw on as part of your answer. The refractive index of the transparent solid is 1.3. The light is incident on the surface of the solid at an angle of incidence of 67°. Calculate the angle of refraction of the light in the solid. angle of refraction = Determine the wavelength of the green light in the transparent solid. wavelength =
3. Waves  →  3.2.2. Refraction of light
Open
7
shows a circuit diagram that includes component X. A 20 Ω X 30 Ω State the name of component X. The electromotive force (e.m.f.) of the battery is E. The switch is closed. The potential difference (p.d.) across the 30 Ω resistor is V30. The p.d. across the 20 Ω resistor is V20. The p.d. across component X is VX. State an equation that relates VX to: V30 E and V20. The e.m.f. of the battery is 6.0 V and the resistance of component X is 15 Ω. Calculate: the total resistance of the circuit resistance = the ammeter reading. reading = The temperature of component X increases. State and explain what happens to the ammeter reading.
4. Electricity and magnetism  →  4.2.4. Resistance
4. Electricity and magnetism  →  4.3.3. Action and use of circuit components
Open
8
A student turns the handle of an alternating current (a.c.) generator and the coil rotates. represents the structure of the a.c. generator. N coil slip rings voltage output handle S coil brush There is an alternating voltage output between the two terminals. Explain why rotating the coil produces an output voltage. State the position of the rotating coil when the alternating output voltage is at a maximum value and explain why the maximum output occurs at this position. A lamp and an open switch are connected in series to the output terminals of the a.c. generator. The switch is closed and the lamp lights up. The student has to apply a greater force on the handle. Explain why a greater force is needed to keep the lamp lit.
4. Electricity and magnetism  →  4.5.2. The a.c. generator
4. Electricity and magnetism  →  4.5.5. The d.c. motor
Open
9
shows a beam of α-particles moving towards a thin sheet of gold in a vacuum. beam of α-particles vacuum detectors gold sheet Detectors in the region surrounding the thin gold sheet detect the α-particles and determine the number of particles that travel in various directions. State and explain what can be deduced from the following observations. The majority of the α-particles pass through the gold sheet undeflected and are detected on the far side. deduction explanation A small number of α-particles are deflected as they pass through the gold sheet. deduction explanation A very small number of α-particles are deflected through very large angles or return back the way they came. deduction explanation A beam that consists of both α-particles and β-particles is passed through a region of space where there is a magnetic field perpendicular to the direction of the beam. State two ways in which the deflection of the α-particles differs from that of the β-particles. 1. 2.
5. Nuclear physics  →  5.1.1. The atom
5. Nuclear physics  →  5.2.2. The three types of nuclear emission
4. Electricity and magnetism  →  4.5.4. Force on a current-carrying conductor
Open